1、金华升降机应停放在干燥的室内，不得已停在室外者，应选平坦的地面并铺上木板，停放后用罩布盖好。长期存放前，须对机械进行保养、修复损坏机件，并对其进行彻底清理，保持技术状态良好。
Jinhua lift should be kept in dry room, compelled to stop the outdoors, should be flat ground and covered with wood, parking cover cover. Before long-term storage, shall be for the mechanical maintenance and repair of damaged parts, and carries on the thorough cleaning, maintain a good technical condition.
2、金华升降机在停机场的排列和布置，应保证任何一台机械的进出均不受其他机械的影响，应将机械的燃油控制杆置于怠速位置，各操纵杆置于空挡位置。
Jinhua lift in stopping the airport arrangement and layout, should ensure that the impact of any one mechanical access from other machinery, should be the fuel control lever in the idle position, the control lever in the neutral position.
3、放掉金华升降机发动机内的冷却水，新机油通常呈中性，不会腐蚀发动机的金属机件，燃油箱加满柴油，避免燃油箱生锈。
Let the cooling water of Jinhua elevator inside the engine, the new oil is usually neutral, will not corrode metal parts of the engine, fuel tank fill diesel fuel tank, avoid rust.
4、金华升降机在停机期间应每月启动一次发动机，使机械作短距离行驶，使各零件润滑处建立新的油膜，防止生锈。应注意在启动前应注满冷却水，结束时应放尽冷却水。
Jinhua lift should start an engine in a month during the shutdown, so that the machinery for short distance driving, so that each part of oil film lubrication is established at the new, prevent rust. Should pay attention to before initiating should fill the cooling water, the end should be placed as far as cooling water.
5、应拆下金华升降机蓄电池，将蓄电池放置在干燥和防冻处。要保持其表面的清洁干燥，严禁在蓄电池上放置导电物体。拆蓄电池时，首先要切断负极线，然后再切断正极线；安装时要先连接正极线，再连接负极线。
Remove the Jinhua lift the battery, the battery is placed in the drying and freezing point. To keep the surface clean and dry, is strictly prohibited in battery is placed on conductive objects. Remove the battery, the first to cut off their negative line, then cut the positive line; when installation should first connect the positive line, then connected with the cathode line.
Jinhua lift storage before, should be considered the outer surface antirust paint paint falls off the size of the area to determine repair or use the machine to paint with paint solution method.